favorite
favorite
hide
unhide
flag

Posted

print

88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr - $1,850 (Gary, Hammond, Griffith)

88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 1 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 2 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 3 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 4 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 5 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 6 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 7 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 8 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 9 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 10 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 11 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 12 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 13 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 14 thumbnail88 StingRay Merc170HP 3.7L I/O Cuddy Cabin 19ft w/Trlr 15 thumbnail
boat type: powerboat
propulsion type: power
condition: good
engine hours (total): 12
length overall (LOA): 19
make / manufacturer: StingRay/Mercruiser
model name / number: SVC199
year manufactured: 1988
1988 StingRay Model SVC199
$1850/Best or trade for Virtual Pinball Machine, E-Bike, Scooter, Motorcycle, Car etc. Freshly Re-Built engine starts right up, Runs Great!
The Good: Less than 12 hours on Rebuilt Engine, New Bellows, all New Hoses and Clamps (Hoses still have stickers on them) Wires and plugs were new at time of rebuild. Engine and Drive run Great, Stainless Steel Prop, Hydraulic Tilt/Trim fine, Blower and Bilge Pump work, Power Steering works, Lights work, Nice Cabin just needs a cleaning Have boat title...

The Bad: No seats, cabin door needs to be reassembled and finished (glass is still good). Needs Motor box built (I found a Nice one here on Facebook, he said make offer) Not much wood but it does need stain/varnish. Should have a Trailer title in about 2 weeks.

You also have the opportunity to test/check anything in any way that makes you feel comfortable with this purchase. , I have a compression tester you are welcome to use.
https://www.michiganmotorz.com/3-7l-470-mercruiser-marine-engine-1976-89
Alpha One Gen 1 SternDrive Gear Ratio=1.84
Tilt Cylinders and hydraulic system Work Fine

Since this engine is a new rebuild you MUST observe proper break-in procedures, as follows...
The first 20-hours of operation will have a dramatic affect relative to overall engine performance and expected engine life. Proper break-in practices reduce the potential for excessive oil consumption. It also helps to achieve better engine performance levels for a longer period of time.
First 20 Hours:
DO NOT operate the engine below 1500 rpm for extended period$ pf time. Shift into gear as soon as possible after starting the engine. Advance the throttle above 1500rpm if conditions permit safe operation.
DO NOT operate at one continuous speed for extended periods of time. Vary the throttle position every ten to fifteen minutes.
DO NOT exceed 3/4 throttle during the first 10 hours of operation. During the next 10 hours you may occasionally operate at full throttle for no more than 5-minutes as a time.
DO NOT operate at full throttle until the engine reaches normal operating temperatures.
Avoid full throttle acceleration from an IDLE speed.

After First 20 Hours:
Refrain from extended periods of Wide-Open-Throttle. We recommend cruising at 3/4 throttle or below for longer term operation.
Change the oil and filter regularly. Refer to the Specifications and Maintenance section of the MerCruiser Owners Guide for recommendations.

post id: 7737893793

posted:

updated:

best of [?]

loading
reading
writing
saving
searching